ScienceDaily (July 21, 2006) — After 10 years of research, the National Institute of Standards and Technology (NIST) has unveiled the world’s first precision instrument for directly measuring alternating current (AC) voltages. The instrument is being tested for use in NIST’s low-voltage calibration service, where it is expected to increase significantly the measurement precision of industrial voltmeters, spectrum analyzers, amplifiers and filters.

Described July 14 at the Conference on Precision Electromagnetic Measurements in Turin, Italy, the patented instrument is based on the same “Josephson junction” technology used in NIST’s widely used direct current (DC) voltage standards, offering high precision based on quantum physics. A Josephson junction consists of two superconducting pieces of metal separated by a thin insulator or normal metal. When a fixed DC voltage is applied across it, a junction responds by generating an AC current that oscillates like a wave at a frequency exactly proportional to the applied voltage.

The new instrument uses arrays of junctions to generate AC pulses in precisely measured voltage units over a range of audio frequencies. Arbitrary waveforms can be generated at different voltage levels for different applications. The new standard would establish an entirely new method for AC voltage metrology. Until now, AC voltage calibrations have been performed indirectly, by measuring the heat delivered by an instrument to a resistor, and comparing that measurement to the heat delivered by a known DC voltage. At low voltages (such as 2 millivolts), the new AC Josephson junction voltage standard should improve measurement accuracy as much as 1,000-fold.

The concept for the new device was co-invented by researchers at NIST and Northrop-Grumman in the mid-1990s. A number of innovations since then have led to the first practical system. For instance, to increase the output voltage, NIST developed “nano-stacked” arrays of Josephson junctions, in which the spacing between junctions is reduced to less than 100 nanometers by stacking the junctions on top of each other. Using this technique NIST can make programmable voltage standard integrated circuits with over 130,000 junctions on a single chip. The new AC instrument currently has a maximum output of 100 millivolts; NIST researchers hope eventually to increase that level to 1 volt.

Email or share this story:  

Related Stories

Josephson Synthesizer Circuit Demonstrated (Jan. 30, 2002) — NIST researchers recently demonstrated sine-wave synthesis on three superconducting integrated circuit chips using palladium-gold barrier junctions. This is a major step toward the goal of developing ...  > read more

Novel 'Noise Thermometry' May Help Redefine International Unit Of Temperature (June 9, 2008) — After seven years of work, researchers at the National Institute of Standards and Technology have built a system that relies on the "noise" of jiggling electrons as a basis for measuring temperatures ...  > read more

New Way To Study Nanostructures Discovered (July 30, 2007) — Physicistshave discovered a phenomenon which allows measurement of the mechanical motion of nanostructures by using the AC Josephson effect. The findings may be used to identify and characterize ...  > read more

Switchyard For Single Electrons (Feb. 25, 2008) — Scientists have transferred very small charge "packets," comprising a well-defined number of few electrons, between metallic electrons precisely by using a single-electron pump. A single-electron ...  > read more

Search ScienceDaily

Voting Machines: Make Your Vote Count!